The way to use stretchy layer?

Considering that the stretchy external surfaces walls color movie has substantial resilience, whenever a split takes place in the walls, the layer motion picture will be extended and deformed without cracking and problems. The still intact layer motion picture will sustain its unique obstacle features and prevent cracking. The walls are directly subjected to the climate. The stretchy fresh paint film has shield qualities against a variety of materials (normal water as well as other drinks, etc.), stopping the intrusion of various corrosive compounds to the indoor from the wall, and thus effectively protecting the walls from hurt and supplying total play to the safety work. So, just how will it be constructed?

Materials needs

"In accordance with the layout requirements, grassroots circumstances, construction environment and season,

Select and acquire elastomeric coatings and also other helping materials. "

Main machinery

" 1. Painting resources: brushes, light brown brushes, buckets, etc. 2. Spraying equipment: air flow compressor (optimum atmosphere tension 10MPa, exhaust chamber .6m3) 3. Spray container, apply pistol, high-tension hose, and so forth. 4. Curler finish instruments: plush curler, embossed curler, generating roller, difficult plastic material or silicone curler 5. Bullet finish tools: guidebook or electric powered bullet coater and helping gear 6. Painting tools: stainless steel trowel, plastic-type material trowel , grey board, and so on. 7. Hands-held electronic stand mixer, and so forth."

Operating problems

1. The ash over the combined mortar on the concrete and wall surface types of surface continues to be finished and dehydrated. Its moisture content material should meet the pursuing requirements: 1. When implementing solvent-centered color at first glance, the dampness content material shall not really greater than 8Per cent 2. When applying water-dependent color on the outside When working with floating painting, the dampness content should not be in excess of ten percent, and be sure there is absolutely no hollowing on the wall.

2. H2o, electricity, equipment, reserved components around the roof wall surface, and embedded components have been completed.

3. The ambient temp when implementing h2o-structured and emulsion paints should be controlled in accordance with the temperature within the merchandise directions. When applying painting inside in the winter months, it ought to be done under home heating conditions. The room temperatures should be held well-balanced and must not alter abruptly.

4. Well before app, the lacking corners and sides of your substrate or bottom layer must be mended with 1:3 concrete mortar (or polymer concrete mortar) work surface pits and spaces must be filled flush with putty (outside walls, kitchen areas, bathrooms and H2o-tolerant putty must be found in bathrooms along with other components that need paint). If you can find hollows in the wall, the hollows needs to be knocked available and repaired with cement mortar.